![]() Temperature is below 45☏ (7☌) - risk of ice*.Īll equipment is automatically switched on until the temperature reaches 45☏ (7☌). Temperature has dropped 50☏ (10☌) below the required temperature The spa will not turn back on automatically. The spa turns off.įollow necessary instructions for the "dr" message. Message appears after the 3rd "dr" message. If the problem continues, contact a specialist. If the water levels are normal, make sure that all the pumps are on. There may be an air bubble in the heating circuit or a lack of flow in the heater. ![]() The message should restart in the following 15 minutes. The heater is off but other funtions are still on. Message appears after the 5th "HL" message in 24 hours.Ĭontinuously insufficient water flow. The Hi-limit overheating sensor may be defective This may be temporary of one of the sensors may be defective If the problem continues, contact a specialist (this message may appear temporarily if the spa overheats).Ī temperature difference was detected between the two M7 sensors. if the spa does not restart, cut off the power supply and contact a specialist. Once the heater has cooled, restart the spa by pressing any button. Remove the cover and let the water cool down. Heater overheating - the spa has stopped* and the temperature detected in the heater is higher than 48☌. If it does not restart, cut off the power supply and contact a specialist. ![]() Once the water reaches 106☏ (41.7☌), the spa should restart automatically. Spa overheating - the spa has stopped* and the temperature detected in the spa is higher than 113☏ (43.5☌). Temperature should appear after the pump has been on for two minutes. If you can't find the message below, feel free to refer to the user manual or to contact us. All Balboa systems use the same error codes on their keypads.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |